 |
Process Pumps |
Process Pumps conforming to ANSI B73.1
Centrifugal - Open type impeller
Horizontal, end suctions, single stage, top center line discharge back pull out
Suitable for any corrosive liquid and slurry applications with or without solid particles
20 models in 1750 rpm and14 models in 3500 rpm
Interchangeable mountings dimension, size, location of suction and discharge nozzles, impeller, shaft, base plate and foundation bolt side.
Clock-wise rotation for coupling end.
Models
Capacity - up to 900 m3/hr
Head - up to 200 m
Temperature - Max 260°C with cooling
Working Pressure - up to 284 psi
Speed - up to 2500 rpm
Flanges: Suction & discharge flange dimensions conforming to ANSI B16.1 class 125 lbs cast iron or ANSI B16.5 class 150 lbs steel standards as to pitch circle, number and size of bolt holes, etc
Shafts & Bearings: Heavy duty shafts & bearings. Rigid shaft designed for minimum deflection at sealing face less than 0.5 mm Bearing sized for 10 years average life. Available with or without shaft sleeve.
Bearing Housing: Extra large, increased oil capacity / Better heat transfer for reduced oil temperature / Bearings run cooler and last longer
Impeller: Open type. Best design for solids handling, stringy material, corrosive, abrasives. Twice the wear of the closed tpe. Back pump out vanes reduce radial thrust loads and seal chamber pressure.
Applications
Acids
Alkalis
Sea water
Corrosive slurries
Hydrocarbons |
10-10-2008 |
|
Recent Listings
